Part single, part two-storey extensions in Belvedere

The basics for Belvedere at a glance.

Postcode districts: DA17 and DA18
County / area: Greater London, England
Price region: London
Guide price: £86,500–£119,000 (£2,400–£3,300 per m²)
Approval route: It may be permitted development if it goes no more than 3 m beyond the original rear wall (counting any single-storey part) and stays 7 m from the rear boundary; otherwise it needs planning permission.
Nearest towns: Erith (1.1 miles), Thamesmead (1.6 miles), Abbey Wood (1.9 miles)
First visit: Free, no obligation

About a part single, part two-storey extension

A part single, part two-storey extension is an extension where the ground floor is wider or deeper than the floor above, so only part of it rises to two storeys. It usually gives a large kitchen or living area with roof lights below and one bedroom or bathroom above. It is often a good way to add space while limiting the effect on neighbours.

We cover Belvedere (DA17 and DA18) and the places around it, including Erith (1.1 miles), Thamesmead (1.6 miles) and Abbey Wood.

What it costs in Belvedere

Using our London rates, a part single, part two-storey extension with a 6 m × 4 m ground floor and a first floor over half of it (36 m² in total) comes to about £86,500–£119,000, including VAT. Bigger or more glazed designs cost more per m². Design fees, structural calculations and approval fees are separate and listed on our prices page.

Spec	Per m²	A 6 m × 4 m ground floor and a first floor over half of it (36 m² in total)
Essential	£2,210–£3,040 per m²	£79,500–£109,500
Standard	£2,400–£3,300 per m²	£86,500–£119,000
Premium	£2,880–£3,960 per m²	£103,500–£142,500

Planning and building regulations in Belvedere

In England, the extension can only be permitted development if it goes no more than 3 m beyond the original rear wall and stays at least 7 m from the rear boundary, with matching materials and roof pitch. We check the whole design against the rules, including the 50% garden coverage limit. If any part fails, or extends beyond a side wall on two floors, you need planning permission, costing £548 (or £575 for applications made from 8 December 2026).

Approval in England: Householder planning application: £548 (or £575 for applications made from 8 December 2026). Lawful development certificate: £274 (about £288 for applications from 8 December 2026). Councils should decide householder applications within 8 weeks of validation.

Building regulations: Building regulations approval (full plans recommended) from the council or a registered building control approver, with a completion certificate at the end.

Design points for Belvedere homes

Where to put the two-storey part

The two-storey section usually works best away from the closest neighbour, with the single-storey part on that boundary side. We test a few positions against neighbours' windows, the upstairs layout and the roof shape before choosing the one to take forward.

Light into the kitchen

The single-storey part is the place for roof lights or a lantern, which bring daylight deep into the plan. In England, glazing is normally limited to 25% of the new floor area plus any windows removed, unless calculations show the house still performs, so we plan the balance early.

How we'd run your project

Visit and first ideas
One of our team visits your house in Belvedere, checks the walls, roof and drains, and sketches out options with you.
Plans, then approval
Measured survey, design, then the right approval route for your house. We explain each step before we take it.
Structure and building control
A structural engineer sizes the foundations and steels, and we get building regulations approval before work starts.
Build and hand over
We manage the build from groundworks to decoration-ready finish and hand over with the completion paperwork.

Questions about part single, part two-storey extensions in Belvedere

Who handles building regulations for a project in Belvedere?

We handle it as part of the project. What's needed in England: building regulations approval (full plans recommended) from the council or a registered building control approver, with a completion certificate at the end. We prepare the drawings and the engineer's calculations, book the inspections and pass you the completion paperwork at the end.

Do I need planning permission for a part single, part two-storey extension in Belvedere?

Belvedere is in England, so England planning rules apply. It may be permitted development if it goes no more than 3 m beyond the original rear wall (counting any single-storey part) and stays 7 m from the rear boundary; otherwise it needs planning permission. If in doubt, a lawful development certificate or a planning application gives you certainty before you build.

Which postcodes do you cover around Belvedere?

We cover Belvedere (DA17 and DA18) and nearby places including Erith, Thamesmead and Abbey Wood, plus the rest of Greater London. The first site visit is free.

Can the single-storey part be deeper than the two-storey part?

With planning permission, yes, and that is often the point of the design: the ground floor projects further into the garden while the first floor stays back from neighbours. Under permitted development, the depth limits for extensions of more than one storey can apply to the whole extension, so we confirm which route applies before drawings are finalised.

Can I add roof lights to the single-storey part?

Yes. Roof lights or a lantern over the single-storey part are one of the main reasons to choose this design, as they light the middle of a deep kitchen. In England they count towards the Part L glazing allowance, normally 25% of the new floor area plus windows removed, so we balance them with the rear doors.

Nearby

Other towns near Belvedere:

Other extensions in Belvedere

All two-storey extension services in Belvedere · Part single, part two-storey extensions across Greater London

Ready to talk it through? Call us or send the form and we'll arrange a visit to your home in Belvedere.