Part single, part two-storey extensions in Earlsfield

Before you start in Earlsfield, here's what applies.

Postcode districts: SW18
County / area: Greater London, England
Price region: London
Guide price: £86,500–£119,000 (£2,400–£3,300 per m²)
Approval route: It may be permitted development if it goes no more than 3 m beyond the original rear wall (counting any single-storey part) and stays 7 m from the rear boundary; otherwise it needs planning permission.
Nearest towns: Wimbledon Park (0.8 miles), Balham (1.5 miles), Tooting (1.6 miles)
First visit: Free, no obligation

About a part single, part two-storey extension

A part single, part two-storey extension is an extension where the ground floor is wider or deeper than the floor above, so only part of it rises to two storeys. It usually gives a large kitchen or living area with roof lights below and one bedroom or bathroom above. It is often a good way to add space while limiting the effect on neighbours.

Around Earlsfield we also work in Wimbledon Park, Balham and Tooting, and across the rest of Greater London. Postcode district in and near Earlsfield: SW18.

What it costs in Earlsfield

A guide price for Earlsfield: around £86,500–£119,000 for a 6 m × 4 m ground floor and a first floor over half of it (36 m² in total). That works out at £2,400–£3,300 per m² of new floor space, including VAT at 20%. These are guides, not quotes. Ground conditions, steelwork and access can move the figure either way.

Spec	Per m²	A 6 m × 4 m ground floor and a first floor over half of it (36 m² in total)
Essential	£2,210–£3,040 per m²	£79,500–£109,500
Standard	£2,400–£3,300 per m²	£86,500–£119,000
Premium	£2,880–£3,960 per m²	£103,500–£142,500

Planning and building regulations in Earlsfield

In England, the extension can only be permitted development if it goes no more than 3 m beyond the original rear wall and stays at least 7 m from the rear boundary, with matching materials and roof pitch. We check the whole design against the rules, including the 50% garden coverage limit. If any part fails, or extends beyond a side wall on two floors, you need planning permission, costing £548 (or £575 for applications made from 8 December 2026).

Approval in England: Householder planning application: £548 (or £575 for applications made from 8 December 2026). Lawful development certificate: £274 (about £288 for applications from 8 December 2026). Councils should decide householder applications within 8 weeks of validation.

Building regulations: Building regulations approval (full plans recommended) from the council or a registered building control approver, with a completion certificate at the end.

Design points for Earlsfield homes

Structure at the step

The first-floor wall above often sits over the new open-plan space, so it needs a steel beam or frame to carry it. Loads come down at different points than in a full two-storey design, and the engineer sizes the foundations to suit each part.

The roof junction

Where the single-storey roof meets the two-storey wall you need a sound weathering detail, usually a lead or similar flashing, and enough height for roof lights or a lantern. We set the roof falls and the upstairs window sill heights together so they do not clash.

How we'd run your project

Understand the brief
At your home in Earlsfield we agree what you need: bedroom count, bathroom, kitchen space, and how much garden you want to keep.
Drawings, then consent
We draw the scheme, check it against the rules in England, and take it through the right consent with the council.
Price it properly
Once the engineer's calculations are in, we fix the build price in writing, with a clear list of what's included.
On site
One project lead runs the job, keeps you updated and arranges inspections at each stage until completion.

Questions about part single, part two-storey extensions in Earlsfield

How long does a part single, part two-storey extension take?

Allow 4 to 8 weeks for survey and design, then the approval period (councils should decide householder applications within 8 weeks of validation), then 4 to 8 weeks of technical design, which can overlap. The build itself usually takes 14 to 20 weeks, longer for large or complex designs.

How much does a part single, part two-storey extension cost in Earlsfield?

Our guide for London, which covers Earlsfield, is £2,400–£3,300 per m² including VAT. A typical project with a 6 m × 4 m ground floor and a first floor over half of it (36 m² in total) comes to about £86,500–£119,000. Design and approval fees are extra, and we fix the build price in writing once the design is agreed.

Who handles building regulations for a project in Earlsfield?

We handle it as part of the project. What's needed in England: building regulations approval (full plans recommended) from the council or a registered building control approver, with a completion certificate at the end. We prepare the drawings and the engineer's calculations, book the inspections and pass you the completion paperwork at the end.

Can the single-storey part be deeper than the two-storey part?

With planning permission, yes, and that is often the point of the design: the ground floor projects further into the garden while the first floor stays back from neighbours. Under permitted development, the depth limits for extensions of more than one storey can apply to the whole extension, so we confirm which route applies before drawings are finalised.

Which side should the two-storey part go on?

Usually the side furthest from the nearest neighbour's windows, so the single-storey part sits nearest them and keeps their light. Other factors are where the stairs land upstairs, which room needs the extra space and where drains run. We sketch options at the design stage and explain which is most likely to be approved.

Nearby

The same service in neighbouring towns:

Other extensions in Earlsfield

All two-storey extension services in Earlsfield · Part single, part two-storey extensions across Greater London

Book a free site visit in Earlsfield and we'll tell you what's possible, what approvals you need and what the design stage would cost.