Structural engineering for two-storey extensions in Hertfordshire

Hertfordshire at a glance

Nation: England
Price region: East of England
Postcode areas: AL, CM, EN, HP, SG, WD
Towns covered: 33 listed below, plus surrounding villages
Site visits: Free, no obligation

What a structural design involves

Structural engineering for a two-storey extension involves calculating how the new floors, walls and roof carry their loads down to the ground, and designing the beams, lintels, foundations and ties into the existing house to suit. The engineer's calculations and drawings form part of the building regulations approval. They also tell the build team exactly what steel and foundations to install.

Hertfordshire towns we list: Watford (WD1), Hemel Hempstead (HP1), Stevenage (SG1), St Albans (AL1), Welwyn Garden City (AL6) and Cheshunt (EN7). Every other address in Hertfordshire is covered as well.

Fees

A structural engineer (calculations and beam design) is a guide of £750–£2,200, priced in writing once the design is known.

Rules in England

In England, structural engineering is part of building regulations approval under Part A rather than planning. The engineer's calculations go to council building control or a registered building control approver with the full plans application. Where more than one contractor is involved, the Building Safety Act dutyholder rules also apply.

Approval in England: Householder planning application: £548 (or £575 for applications made from 8 December 2026). Lawful development certificate: £274 (about £288 for applications from 8 December 2026). Councils should decide householder applications within 8 weeks of validation.

Building regulations: Building regulations approval (full plans recommended) from the council or a registered building control approver, with a completion certificate at the end.

The Party Wall etc. Act 1996 applies, so notices may be needed for work on or near a shared wall or boundary.

Getting the design right

Foundations for two storeys

Two storeys put more load on the ground than one, so foundations are usually deeper or wider. Clay soil, nearby trees, drains and made-up ground can all mean deeper trench fill or piles, which is why we dig trial holes before fixing the design.

Building on existing structure

When building over a garage or a single-storey extension, the engineer checks the existing footings, walls and lintels. Many were sized for one storey only and need underpinning, strengthening or replacement to carry the new floor.

How we work in Hertfordshire

Measure and listen
A visit to Hertfordshire to understand how you live in the house now and what the extra rooms need to do, plus a first look at the structure.
Design and approvals
We draw the extension and check it against the rules for England, then apply for planning permission or a certificate of lawfulness, whichever fits.
Technical design
We prepare the building regulations drawings, structural calculations and specification so the build price can be fixed.
Finish and certify
Second fix, plastering and making good, then building control's final inspection and the completion paperwork.

Towns we cover in Hertfordshire

Structural engineering for two-storey extensions in Hertfordshire: questions

Will the engineer visit the site during the build?

Not usually at every stage. Building control inspects the foundations, steelwork and other key stages against the approved calculations. The engineer is called back if site conditions differ from the design, such as unexpected ground, hidden beams or weak existing walls, and issues revised details before that part of the work continues.

How deep do foundations need to be for a two-storey extension?

There is no single depth. It depends on the soil, nearby trees, drains and the loads. On firm ground foundations may be around a metre deep, while clay near trees can need much deeper trench fill or piles. Trial holes and the engineer's design set the depth, and building control inspects the trenches.

Can a steel beam be hidden in the ceiling?

Often, yes. A beam can sit within the floor depth so the ceiling is flat, but that may mean a deeper steel section or a different floor structure. Otherwise it shows as a downstand below the ceiling. We discuss the options with you and the engineer before the design is fixed.

Neighbouring areas

All extension services in Hertfordshire · About structural engineering for two-storey extensions