Structural engineering for two-storey extensions in Northumberland
Our structural engineering service covers the whole of Northumberland. Choose your town below, or get in touch to talk your project through.
Northumberland at a glance
- Nation
- England
- Price region
- North East England
- Postcode areas
- NE, TD
- Towns covered
- 19 listed below, plus surrounding villages
- Site visits
- Free, no obligation
What a structural design involves
This service suits every two-storey extension, because each one needs foundations sized for two storeys and usually steel beams where walls are removed. You get a structural engineer's calculations and drawings for beams, padstones, lintels, foundations and connections, coordinated with the architectural drawings, submitted for building control and followed through on site by our build teams.
Across Northumberland we cover Blyth (NE24), Cramlington (NE23), Ashington (NE63), Bedlington (NE22), Darras Hall (NE18) and Morpeth (NE61), plus the smaller places around them.
Fees
A structural engineer (calculations and beam design) is a guide of £750–£2,200, priced in writing once the design is known.
Rules in England
In England, structural engineering is part of building regulations approval under Part A rather than planning. The engineer's calculations go to council building control or a registered building control approver with the full plans application. Where more than one contractor is involved, the Building Safety Act dutyholder rules also apply.
Approval in England: Householder planning application: £548 (or £575 for applications made from 8 December 2026). Lawful development certificate: £274 (about £288 for applications from 8 December 2026). Councils should decide householder applications within 8 weeks of validation.
Building regulations: Building regulations approval (full plans recommended) from the council or a registered building control approver, with a completion certificate at the end.
The Party Wall etc. Act 1996 applies, so notices may be needed for work on or near a shared wall or boundary.
Getting the design right
Tying into the house
The new walls and floors are tied into the existing house with wall ties, restraint straps and joist hangers. The engineer also considers movement between the old and new foundations and where a movement joint may be needed.
Beams and padstones
Steel beams carry the first floor and roof over openings, and they sit on padstones that spread the load into the walls. The engineer sizes each beam and checks the walls can take the point loads, which affects ceiling heights and where posts can go.
How we work in Northumberland
Measure and listen
A visit to Northumberland to understand how you live in the house now and what the extra rooms need to do, plus a first look at the structure.
Drawings, then consent
We draw the scheme, check it against the rules in England, and take it through the right consent with the council.
Price it properly
Once the engineer's calculations are in, we fix the build price in writing, with a clear list of what's included.
Build it
The new structure goes up first, then we open into the house, finish inside and get the completion certificate.
Towns we cover in Northumberland
- Blyth
- Cramlington
- Ashington
- Bedlington
- Darras Hall
- Morpeth
- Prudhoe
- Berwick-upon-Tweed
- Hexham
- Ponteland
- Stakeford
- Alnwick
- Newbiggin-by-the-Sea
- Amble
- Cowpen
- Haltwhistle
- Hadston
- Pegswood
- Choppington
Structural engineering for two-storey extensions in Northumberland: questions
What are trial holes and why do I need them?
Trial holes are small excavations dug next to the house or garage to see the depth and condition of the existing foundations and the soil. They tell the engineer whether existing footings can be reused and how deep the new ones need to go, which avoids surprises during the build.
Do I need a structural engineer for a two-storey extension?
Almost always. Building control needs calculations showing that the foundations, beams and walls can carry the loads of two storeys and a roof. A two-storey extension usually involves removing part of an outside wall and new steel, which needs an engineer's design.
How deep do foundations need to be for a two-storey extension?
There is no single depth. It depends on the soil, nearby trees, drains and the loads. On firm ground foundations may be around a metre deep, while clay near trees can need much deeper trench fill or piles. Trial holes and the engineer's design set the depth, and building control inspects the trenches.
Neighbouring areas
- Structural engineering for two-storey extensions in Tyne and Wear
- Structural engineering for two-storey extensions in County Durham
- Structural engineering for two-storey extensions in the Scottish Borders
- Structural engineering for two-storey extensions in North Yorkshire
All extension services in Northumberland · About structural engineering for two-storey extensions
Ready to see what a second storey could do for your home?
Book a free site visit. We'll look at your house, talk through options and explain the approvals you'd need, then price the design stage in writing.