Lancashire · England

Structural engineering for two-storey extensions in Lancashire

Our structural engineering service covers the whole of Lancashire. Choose your town below, or get in touch to talk your project through.

Lancashire at a glance

Nation
England
Price region
North West England
Postcode areas
BB, FY, L, LA, OL, PR, WN
Towns covered
30 listed below, plus surrounding villages
Site visits
Free, no obligation

What a structural design involves

Structural engineering for a two-storey extension involves calculating how the new floors, walls and roof carry their loads down to the ground, and designing the beams, lintels, foundations and ties into the existing house to suit. The engineer's calculations and drawings form part of the building regulations approval. They also tell the build team exactly what steel and foundations to install.

Across Lancashire we cover Preston (PR1), Burnley (BB10), Blackburn (BB1), Blackpool (FY1), Morecambe (LA4) and Lancaster (LA1), plus the smaller places around them.

Fees

A structural engineer (calculations and beam design) is a guide of £750–£2,200, priced in writing once the design is known.

Rules in England

In England, structural engineering is part of building regulations approval under Part A rather than planning. The engineer's calculations go to council building control or a registered building control approver with the full plans application. Where more than one contractor is involved, the Building Safety Act dutyholder rules also apply.

Approval in England: Householder planning application: £548 (or £575 for applications made from 8 December 2026). Lawful development certificate: £274 (about £288 for applications from 8 December 2026). Councils should decide householder applications within 8 weeks of validation.

Building regulations: Building regulations approval (full plans recommended) from the council or a registered building control approver, with a completion certificate at the end.

The Party Wall etc. Act 1996 applies, so notices may be needed for work on or near a shared wall or boundary.

Getting the design right

Foundations for two storeys

Two storeys put more load on the ground than one, so foundations are usually deeper or wider. Clay soil, nearby trees, drains and made-up ground can all mean deeper trench fill or piles, which is why we dig trial holes before fixing the design.

Building on existing structure

When building over a garage or a single-storey extension, the engineer checks the existing footings, walls and lintels. Many were sized for one storey only and need underpinning, strengthening or replacement to carry the new floor.

How we work in Lancashire

  1. Start at your house

    We come to your home in Lancashire, measure up, check the ground floor walls and roof structure, and note anything near the boundaries.

  2. Plans, then approval

    Measured survey, design, then the right approval route for your house. We explain each step before we take it.

  3. Detail and price

    Construction drawings, engineer's calculations and building control sign-off, then a written fixed price for the build.

  4. Build it

    The new structure goes up first, then we open into the house, finish inside and get the completion certificate.

Towns we cover in Lancashire

Structural engineering for two-storey extensions in Lancashire: questions

What are trial holes and why do I need them?

Trial holes are small excavations dug next to the house or garage to see the depth and condition of the existing foundations and the soil. They tell the engineer whether existing footings can be reused and how deep the new ones need to go, which avoids surprises during the build.

Can a steel beam be hidden in the ceiling?

Often, yes. A beam can sit within the floor depth so the ceiling is flat, but that may mean a deeper steel section or a different floor structure. Otherwise it shows as a downstand below the ceiling. We discuss the options with you and the engineer before the design is fixed.

How deep do foundations need to be for a two-storey extension?

There is no single depth. It depends on the soil, nearby trees, drains and the loads. On firm ground foundations may be around a metre deep, while clay near trees can need much deeper trench fill or piles. Trial holes and the engineer's design set the depth, and building control inspects the trenches.

Neighbouring areas

All extension services in Lancashire · About structural engineering for two-storey extensions

Ready to see what a second storey could do for your home?

Book a free site visit. We'll look at your house, talk through options and explain the approvals you'd need, then price the design stage in writing.

CallGuide price