Structural engineering for two-storey extensions in Merseyside
Planning an extension in Merseyside? This is how our structural engineering service works, with the England rules and typical fees.
Merseyside at a glance
- Nation
- England
- Price region
- North West England
- Postcode areas
- CH, L, PR, WA
- Towns covered
- 42 listed below, plus surrounding villages
- Site visits
- Free, no obligation
What a structural design involves
This service suits every two-storey extension, because each one needs foundations sized for two storeys and usually steel beams where walls are removed. You get a structural engineer's calculations and drawings for beams, padstones, lintels, foundations and connections, coordinated with the architectural drawings, submitted for building control and followed through on site by our build teams.
Towns in Merseyside include Liverpool (L1), Birkenhead (CH41), St Helens (WA9), Southport (PR8), Wallasey (CH44) and Bootle (L22). If yours isn't listed, we still cover it.
Fees
A structural engineer (calculations and beam design) is a guide of £750–£2,200, priced in writing once the design is known.
Rules in England
In England, structural engineering is part of building regulations approval under Part A rather than planning. The engineer's calculations go to council building control or a registered building control approver with the full plans application. Where more than one contractor is involved, the Building Safety Act dutyholder rules also apply.
Approval in England: Householder planning application: £548 (or £575 for applications made from 8 December 2026). Lawful development certificate: £274 (about £288 for applications from 8 December 2026). Councils should decide householder applications within 8 weeks of validation.
Building regulations: Building regulations approval (full plans recommended) from the council or a registered building control approver, with a completion certificate at the end.
The Party Wall etc. Act 1996 applies, so notices may be needed for work on or near a shared wall or boundary.
Getting the design right
Foundations for two storeys
Two storeys put more load on the ground than one, so foundations are usually deeper or wider. Clay soil, nearby trees, drains and made-up ground can all mean deeper trench fill or piles, which is why we dig trial holes before fixing the design.
Tying into the house
The new walls and floors are tied into the existing house with wall ties, restraint straps and joist hangers. The engineer also considers movement between the old and new foundations and where a movement joint may be needed.
How we work in Merseyside
Start at your house
We come to your home in Merseyside, measure up, check the ground floor walls and roof structure, and note anything near the boundaries.
Drawings, then consent
We draw the scheme, check it against the rules in England, and take it through the right consent with the council.
Engineer it
Foundations sized for two floors, steels for any openings, and building control approval, all before anyone starts on site.
Build and hand over
We manage the build from groundworks to decoration-ready finish and hand over with the completion paperwork.
Towns we cover in Merseyside
- Liverpool
- Birkenhead
- St Helens
- Southport
- Wallasey
- Bootle
- Bebington
- Huyton
- Kirkby
- Prescot
- Heswall
- Maghull
- Newton-le-Willows
- Golborne
- Formby
- Litherland
- Speke
- Garston
- Halewood
- Norris Green
- Kirkdale
- Moreton
- Haydock
- Kensington
- Fazakerley
- Hunts Cross
- Belle Vale
- Old Swan
- Allerton
- Bromborough
- Croxteth
- Prenton
- Knotty Ash
- Wavertree
- West Derby
- Childwall
- Whiston
- Dingle
- Woolton
- Mossley Hill
- Rainhill
- Greasby
Structural engineering for two-storey extensions in Merseyside: questions
How deep do foundations need to be for a two-storey extension?
There is no single depth. It depends on the soil, nearby trees, drains and the loads. On firm ground foundations may be around a metre deep, while clay near trees can need much deeper trench fill or piles. Trial holes and the engineer's design set the depth, and building control inspects the trenches.
Can a steel beam be hidden in the ceiling?
Often, yes. A beam can sit within the floor depth so the ceiling is flat, but that may mean a deeper steel section or a different floor structure. Otherwise it shows as a downstand below the ceiling. We discuss the options with you and the engineer before the design is fixed.
What are trial holes and why do I need them?
Trial holes are small excavations dug next to the house or garage to see the depth and condition of the existing foundations and the soil. They tell the engineer whether existing footings can be reused and how deep the new ones need to go, which avoids surprises during the build.
Neighbouring areas
- Structural engineering for two-storey extensions in Cheshire
- Structural engineering for two-storey extensions in Clwyd
- Structural engineering for two-storey extensions in Greater Manchester
- Structural engineering for two-storey extensions in Lancashire
All extension services in Merseyside · About structural engineering for two-storey extensions
Ready to see what a second storey could do for your home?
Book a free site visit. We'll look at your house, talk through options and explain the approvals you'd need, then price the design stage in writing.