Structural engineering for two-storey extensions in Perth and Kinross
Planning an extension in Perth and Kinross? This is how our structural engineering service works, with the Scotland rules and typical fees.
Perth and Kinross at a glance
- Nation
- Scotland
- Price region
- Scotland
- Postcode areas
- KY, PH
- Towns covered
- 8 listed below, plus surrounding villages
- Site visits
- Free, no obligation
What a structural design involves
This service suits every two-storey extension, because each one needs foundations sized for two storeys and usually steel beams where walls are removed. You get a structural engineer's calculations and drawings for beams, padstones, lintels, foundations and connections, coordinated with the architectural drawings, submitted for building standards and followed through on site by our build teams.
Towns in Perth and Kinross include Perth (PH1), Blairgowrie and Rattray (PH10), Crieff (PH5), Auchterarder (PH3), Scone (PH2) and Kinross (KY13). If yours isn't listed, we still cover it.
Fees
A structural engineer (calculations and beam design) is a guide of £750–£2,200, priced in writing once the design is known.
Rules in Scotland
In Scotland, structural calculations form part of the building warrant application, assessed against the Scottish Building Standards Technical Handbooks rather than Approved Documents. The council's building standards service must grant the warrant before any structural work starts, and a completion certificate is submitted when the work is finished.
Approval in Scotland: Householder planning application: £371. Councils have two months to decide a local planning application.
Building standards: A building warrant from the council's building standards service before work starts, and a completion certificate at the end. Scotland uses its own Technical Handbooks.
There is no Party Wall Act in Scotland. Shared walls and boundaries are governed by title deeds and common law, so we speak to neighbours early and record the condition of shared structures.
Getting the design right
Building on existing structure
When building over a garage or a single-storey extension, the engineer checks the existing footings, walls and lintels. Many were sized for one storey only and need underpinning, strengthening or replacement to carry the new floor.
Tying into the house
The new walls and floors are tied into the existing house with wall ties, restraint straps and joist hangers. The engineer also considers movement between the old and new foundations and where a movement joint may be needed.
How we work in Perth and Kinross
Visit and first ideas
One of our team visits your house in Perth and Kinross, checks the walls, roof and drains, and sketches out options with you.
Drawings, then consent
We draw the scheme, check it against the rules in Scotland, and take it through the right consent with the council.
Technical design
We prepare the building warrant drawings, structural calculations and specification so the build price can be fixed.
On site
One project lead runs the job, keeps you updated and arranges inspections at each stage until completion.
Towns we cover in Perth and Kinross
Structural engineering for two-storey extensions in Perth and Kinross: questions
Do I need a structural engineer for a two-storey extension?
Almost always. Building standards needs calculations showing that the foundations, beams and walls can carry the loads of two storeys and a roof. A two-storey extension usually involves removing part of an outside wall and new steel, which needs an engineer's design.
Will the engineer visit the site during the build?
Not usually at every stage. Building standards inspects the foundations, steelwork and other key stages against the approved calculations. The engineer is called back if site conditions differ from the design, such as unexpected ground, hidden beams or weak existing walls, and issues revised details before that part of the work continues.
Can a steel beam be hidden in the ceiling?
Often, yes. A beam can sit within the floor depth so the ceiling is flat, but that may mean a deeper steel section or a different floor structure. Otherwise it shows as a downstand below the ceiling. We discuss the options with you and the engineer before the design is fixed.
Neighbouring areas
- Structural engineering for two-storey extensions in Fife
- Structural engineering for two-storey extensions in Falkirk, Stirling and Clackmannanshire
- Structural engineering for two-storey extensions in Dundee and Angus
- Structural engineering for two-storey extensions in Edinburgh and the Lothians
All extension services in Perth and Kinross · About structural engineering for two-storey extensions
Ready to see what a second storey could do for your home?
Book a free site visit. We'll look at your house, talk through options and explain the approvals you'd need, then price the design stage in writing.