Structural engineering for two-storey extensions in Herefordshire

Herefordshire at a glance

Nation: England
Price region: West Midlands
Postcode areas: HR
Towns covered: 8 listed below, plus surrounding villages
Site visits: Free, no obligation

What a structural design involves

This service suits every two-storey extension, because each one needs foundations sized for two storeys and usually steel beams where walls are removed. You get a structural engineer's calculations and drawings for beams, padstones, lintels, foundations and connections, coordinated with the architectural drawings, submitted for building control and followed through on site by our build teams.

Across Herefordshire we cover Hereford (HR1), Leominster (HR6), Ross-on-Wye (HR9), Ledbury (HR8), Bromyard (HR7) and Belmont (Herefordshire) (HR2), plus the smaller places around them.

Fees

A structural engineer (calculations and beam design) is a guide of £750–£2,200, priced in writing once the design is known.

Rules in England

In England, structural engineering is part of building regulations approval under Part A rather than planning. The engineer's calculations go to council building control or a registered building control approver with the full plans application. Where more than one contractor is involved, the Building Safety Act dutyholder rules also apply.

Approval in England: Householder planning application: £548 (or £575 for applications made from 8 December 2026). Lawful development certificate: £274 (about £288 for applications from 8 December 2026). Councils should decide householder applications within 8 weeks of validation.

Building regulations: Building regulations approval (full plans recommended) from the council or a registered building control approver, with a completion certificate at the end.

The Party Wall etc. Act 1996 applies, so notices may be needed for work on or near a shared wall or boundary.

Getting the design right

Building on existing structure

When building over a garage or a single-storey extension, the engineer checks the existing footings, walls and lintels. Many were sized for one storey only and need underpinning, strengthening or replacement to carry the new floor.

Tying into the house

The new walls and floors are tied into the existing house with wall ties, restraint straps and joist hangers. The engineer also considers movement between the old and new foundations and where a movement joint may be needed.

How we work in Herefordshire

Visit and first ideas
One of our team visits your house in Herefordshire, checks the walls, roof and drains, and sketches out options with you.
Design and approvals
We draw the extension and check it against the rules for England, then apply for planning permission or a certificate of lawfulness, whichever fits.
Fixed price in writing
With approved drawings and calculations, we give you a fixed build price and a programme you can plan around.
Build it
The new structure goes up first, then we open into the house, finish inside and get the completion certificate.

Towns we cover in Herefordshire

Structural engineering for two-storey extensions in Herefordshire: questions

Can a steel beam be hidden in the ceiling?

Often, yes. A beam can sit within the floor depth so the ceiling is flat, but that may mean a deeper steel section or a different floor structure. Otherwise it shows as a downstand below the ceiling. We discuss the options with you and the engineer before the design is fixed.

How deep do foundations need to be for a two-storey extension?

There is no single depth. It depends on the soil, nearby trees, drains and the loads. On firm ground foundations may be around a metre deep, while clay near trees can need much deeper trench fill or piles. Trial holes and the engineer's design set the depth, and building control inspects the trenches.

Do I need a structural engineer for a two-storey extension?

Almost always. Building control needs calculations showing that the foundations, beams and walls can carry the loads of two storeys and a roof. A two-storey extension usually involves removing part of an outside wall and new steel, which needs an engineer's design.

Neighbouring areas

All extension services in Herefordshire · About structural engineering for two-storey extensions